Help im lost

  • Hello and help please


    Installed omv5 on odroid hc4 on a micro sd. Using 2 4tb drives in raid ext4..............so far so good

    Made a backup image to fallback on.

    Following techno dad life on youtube.

    Setup "one" dir and reset perms.

    Installed docker, portainer and yacht............so far so good

    Installed Jackett,lidarr,sonarr,radarr,qbitorrent...........now problems begin.


    Yacht keeps losing selfhosted template and template settings. Cannot get into the store area

    Jackett,lidarr,sonarr,radarr I set them up to comincate works ok. I reboot all settings lost.

    lidarr,sonarr,radarr all share a common problem. I cannot point them to root folders for media. /srv/ just looks empty in the apps but in OMV i can see the drive?


    I think ive run through the setup 11 times now. Anyone know. Any help?


    WARNING: I am very n00b at linux type systems best to state that now. ^^

  • Can anyone help?

    Symlinks shows the mount but lidarr,radarr and sonarr cannot see it. Impossible to point them to the media folders.


    Ive set this up coutless times now. Now running armbian buster.





  • Show a screen shot of your Symlinks page in the GUI so we can see how your Sources and Destinations are set up.

    Easy data backup: In a Scheduled Job: rsync -av --delete /srv/dev-disk-by-label-SOURCE/ /srv/dev-disk-by-label-DESTINATION/ (HT: Getting Started with OMV5)
    OMV 5 (current) - Thinkserver TS140, Nextcloud, Plex, Airsonic, Navidrome, Ubooquity, Digikam, Wetty, & Heimdall - NanoPi M4 (v.1): backups using Rsync and Rsnapshot - Odroid XU4 (Using DietPi): PiHole - hc2, xu4, Pi 3B+, Odroid H2, and VirtualBox: Testing and playing - Mac user converting to Linux, Debian 10 KDE.

  • Agricola

    Added the Label OMV 5.x
  • Everytime I setup symlinks it says "Folder on directory exists!" so i have none setup

    Ive also tried "mergerfs folders" with no result so i have none setup


    Both see the srv/harddrive directory but docker apps do not see it in GUI.

    The docker apps do setup there own directories on the harddrive.


    I just dont understand or know how to solve this


    Huge thanks for replying

  • root@odroidhc4:~# lsblk | grep sd

    sda 8:0 0 1.8T 0 disk

    sdb 8:16 0 1.8T 0 disk


    The 2 drives are in raid 0 mode created under OMV.

    Something odd ive noticed is

    Under "Disks" i can wipe each drive

    Under "Raid" I cannot remove or delete it reports state is clean

    Under "file systems" I cannot mount or unmount or delete

  • root@odroidhc4:~# nano /etc/fstab

    GNU nano 3.2 /etc/fstab


    UUID=abcced1c-61bb-4ef3-a5e6-df94459ccb48 / ext4 noatime,nodiratime,defaults,commit=600,errors=remount-ro 0 1

    tmpfs /tmp tmpfs defaults,nosuid 0 0

    # >>> [openmediavault]

    /dev/disk/by-uuid/e42bb421-b1eb-4289-899c-f39cdc038fc4 /srv/dev-disk-by-uuid-e42bb421-b1eb-4289-899c-f39cdc038fc4 ext4 defaults,nofail,user_xattr,usrjquota=aquota.user,grpjquota=a$

    # <<< [openmediavault]

  • I don’t use a Raid setup, and am not familiar with it either, so I don’t know how a Raid configuration would interact with Symlinks. It sounds like you have an underlying issue with how your Raid is set up. Sorry I can’t be any help.

    Easy data backup: In a Scheduled Job: rsync -av --delete /srv/dev-disk-by-label-SOURCE/ /srv/dev-disk-by-label-DESTINATION/ (HT: Getting Started with OMV5)
    OMV 5 (current) - Thinkserver TS140, Nextcloud, Plex, Airsonic, Navidrome, Ubooquity, Digikam, Wetty, & Heimdall - NanoPi M4 (v.1): backups using Rsync and Rsnapshot - Odroid XU4 (Using DietPi): PiHole - hc2, xu4, Pi 3B+, Odroid H2, and VirtualBox: Testing and playing - Mac user converting to Linux, Debian 10 KDE.

  • Took out a hard drive. Now only using sata slot 1 on the board.

    Done a fresh armbian buster flash and omv install.

    Done the setup all over again and .......................... still the same


    Ive made the /srv directory a shared smb and i can browse through the directories but the apps just sees /srv as an empty directory

  • It sees the music folder but i cannot appoint it as root folder


    Can it be changed or made to work in the config.xml file found in appdata? Is mine correct?



    - <Config>

    <LogLevel>info</LogLevel>

    <BindAddress>*</BindAddress>

    <EnableSsl>False</EnableSsl>

    <SslCertPath />

    <Port>8686</Port>

    <UrlBase />

    <ApiKey>e9312ca5246a4932b9edb5013f06</ApiKey>

    <AuthenticationMethod>None</AuthenticationMethod>

    <UpdateMechanism>Docker</UpdateMechanism>

    <SslPort>6868</SslPort>

    <LaunchBrowser>True</LaunchBrowser>

    <Branch>master</Branch>

    <SslCertPassword />

    </Config>

  • Did you wipe, format, and mount the disk fresh after installing OMV fresh? From the GUI?


    I'm sorry but nothing you are showing is registering with me. Are you installing your services with docker-compose yml's on the command line, or from Portainer with images, or with Portainer Stacks?

    Easy data backup: In a Scheduled Job: rsync -av --delete /srv/dev-disk-by-label-SOURCE/ /srv/dev-disk-by-label-DESTINATION/ (HT: Getting Started with OMV5)
    OMV 5 (current) - Thinkserver TS140, Nextcloud, Plex, Airsonic, Navidrome, Ubooquity, Digikam, Wetty, & Heimdall - NanoPi M4 (v.1): backups using Rsync and Rsnapshot - Odroid XU4 (Using DietPi): PiHole - hc2, xu4, Pi 3B+, Odroid H2, and VirtualBox: Testing and playing - Mac user converting to Linux, Debian 10 KDE.

  • Everytime i start over i do this:


    Wipe sd card in laptop

    Go to odroid hc4 and turn it on

    Odroid exit to console

    netboot_default then exit

    Install debian buster 10 (not sure on partition setup)

    Install debian

    Install OMV as instructed HERE

    Then follow this setup HERE for the OMV part not the debian bit

    Tried hard drives in RAID 0 mode and 1 at a time and side by side

    Then install Yacht like this HERE

    Install apps using yacht


    I have also been trying THIS debian setup

    and this OMV SETUP


    Ive also tried removing petitboot and used debian and armbian

    Ive also updated petitboot from HERE


    Hardware:

    Odroid HC4

    16gb micro sd UHS-1 U1 80mb/s -- got 3 of these 2 weeks old

    toshiba 1.8TB -- mechanical passes smart test

    western digital 1.8tb -- mechanical passes smart test

  • Unfortunately when you post something like this (especially when it's pointing at empty directories).. it's impossible to help when you don't post the docker-compose file you're using. I suspect you've put your paths improperly in your volumes.

    Air Conditioners are a lot like PC's... They work great until you open Windows.


  • Everytime i start over i do this:

    Now I know what you are doing. Thought one of us was on drugs.

    Paying special attention to the Armbian instructions for -> removing petitboot, try the installation guide found -> here.

    Best advice you can find for the price!

    post the docker-compose file you're using.

    Yes!

    Easy data backup: In a Scheduled Job: rsync -av --delete /srv/dev-disk-by-label-SOURCE/ /srv/dev-disk-by-label-DESTINATION/ (HT: Getting Started with OMV5)
    OMV 5 (current) - Thinkserver TS140, Nextcloud, Plex, Airsonic, Navidrome, Ubooquity, Digikam, Wetty, & Heimdall - NanoPi M4 (v.1): backups using Rsync and Rsnapshot - Odroid XU4 (Using DietPi): PiHole - hc2, xu4, Pi 3B+, Odroid H2, and VirtualBox: Testing and playing - Mac user converting to Linux, Debian 10 KDE.

  • Paying special attention to the Armbian instructions for -> removing petitboot, try the installation guide found -> here.

    Installed again following this method. Same result. I cannot appoint root in lidarr. Not sure which file is the docker compose file. I think its the inspect file in portainer? Here it is in text mode and a screenshot.


    I thought my username made things obvious :)

  • Installed again following this method. Same result. I cannot appoint root in lidarr. Not sure which file is the docker compose file. I think its the inspect file in portainer? Here it is in text mode and a screenshot.


    I thought my username made things obvious :)

    If you're using Portainer, post the volumes section. Looking at your inspect, you've not assigned any volumes.


    Edit: Nevermind, I see the mount points now.

    Air Conditioners are a lot like PC's... They work great until you open Windows.


  • Im starting to wonder if the hardware is faulty. Is there some kind of self test for the odroid hc4? The harddrives are green pass on the smart test.


    Or what if I reinstall petitboot. Install Debian onto the harddrives? Make the smb folder in /srv ? would that work?

  • Is there some kind of self test for the odroid hc4?


    I wouldn't assume that there's a hardware issue, based on anything related to issues in setting up a Docker. (Which can be tricky, depending on a variety of factors.)


    With SBC's, most hardware issues are related to - in this order:

    - A bad SD-card

    - Under powering or a bad power supply.


    The first is easy, get and test a new card. The second issue is less likely, in your case, because adequate power supplies are part of the HC4 package.

    ________________________________________________________


    If you think there's a hardware problem, start looking at your logs:


    - With PuTTY, scroll through the output of dmesg on the CLI. Most outputs of concern will be in red.

    - Look through syslog, in the GUI.

    - Activate SMART and look at the stat's of your hard drive(s). (It seems you've already done this.)


    The following are the SMART stat's of concern. One or two in the raw count doesn't mean anything, except to be watchful. Four or five and I'd be ordering a new drive as a replacement.


    SMART 5 – Reallocated_Sector_Count.

    SMART 187 – Reported_Uncorrectable_Errors.

    SMART 188 – Command_Timeout.

    SMART 197 – Current_Pending_Sector_Count.

    SMART 198 – Offline_Uncorrectable.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!