Update-Problems and lots of Monitoring alerts

  • Hello all,


    I'm new to OpenMediaVault. Just installed it a few weeks ago (~4). So I'm not familar with OMV yet. Pls move the thread to the appropriate category, if it's not correct in this one.


    The system in short: ASRock Q1900M Board (Celeron J1900) with 4 GB RAM, Systemdrive is a Crucial 250 GB SSD, Datadrive (only one) is a Seagate Iron Wolf 4 TB.

    No Add-ons, pure OMV ISO with prepared USB-Stick.


    OMV is working well so far but I've recognized Update-Problems from the beginning. I decided to care later. Today the system startet to send lots of Monitoring alerts. Extract:

    Along with that I saw that the graphs stopped somewhere around KW39. So I could not review the 'Resource limit succeeded' alerts, e.g. 'current mem usage = 90.1%'.


    This one is probably of most interest:


    Usually there is a Firewall Rule in place to prevent the OMV from accessing the internet. So I disabled this rule to perform an Update. First attempt was not successfull (Error Message follows). Did a reboot and tried again. Now some Updates where found and could be installed. Clicking 'Prüfen' (presumably Check in EN) again still results in this Error Message:

    Pretty much the same as with the first attempt but a little shorter.


    What's the problem here and how can I solve it?


    Best regards,

    A. Dent

  • A.Dent

    Hat den Titel des Themas von „Update-Problems and losts of Monitoring alerts“ zu „Update-Problems and lots of Monitoring alerts“ geändert.
  • Hello macom,


    thx for the hint. On the one hand, yes, relating rule was disabled, but on the other hand there is also an UTM Appliance with a HTTPS Proxy in charge. I guess 'Certificate verification failed' is what you want to point me to?


    I'll test but I'm in vacation until next week. So I'll test and update next week.


    Best regards,

    A. Dent

  • Hello all,


    according to the hint by macom

    Code
    https://packages.openmediavault.org/public
    https://deb.debian.org/debian

    have been excluded from the https proxy but to no avail. Still the same error in the certificate verification. Are there other requested targets to be added that did not show up in the log yet?


    Is it possible to update by hand and how could I perform that?


    Best regards,

    A. Dent

  • Yes, that's working:


    Is it possible to update manually?

    Or can I assign a second IP to my OMV (with only the onboard NIC)? That would allow me to put it temporary into a different network without that https proxy.


    Best regards,

    A. Dent

    • Offizieller Beitrag

    Or can I assign a second IP to my OMV (with only the onboard NIC)?

    Probably using macvlan.



    hat would allow me to put it temporary into a different network without that https proxy.

    Why not do that with the IP you have?

  • macom

    Hat das Label gelöst hinzugefügt.

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!