The two USB3 ports of the PI are actually the same BUS. They follow the same "road" and it is just as wide whether there is one disc or five.
Thanks for educating me, that was interesting to know.
Adding second external 2 TB WD My Passport to RPi4 Installation causes both drives to make a clicking sound and vanish from blkid
-
- OMV 6.x
- gelöst
- TakerTX
-
Make sure the card is in good condition. Format the card with the program suggested in the guide. This can lead to weird issues sometimes. If it is a new card you will have guarantees.
-
Make sure the card is in good condition. Format the card with the program suggested in the guide. This can lead to weird issues sometimes. If it is a new card you will have guarantees.
it is indeed a new card I purchased for this exact project. And the programs mentioned in the guide are all windows based programs but I am running all Linux OS installations on my machine. Any viable alternative from the Linux world I can use to achieve the same?
-
Thanks for educating me, that was interesting to know.
That's precisely where the problem with energy comes from. The energy provided by this BUS is always the same, no matter what you connect, and it has a limit.
-
-
You should be able to use the RPi imager on Linux, this downloads and deploys the RPi OS onto the SD card you just have to ensure you select the correct RPi OS (Raspberry Pi OS Lite)
-
You should be able to use the RPi imager on Linux, this downloads and deploys the RPi OS onto the SD card you just have to ensure you select the correct RPi OS (Raspberry Pi OS Lite)
The RPi Install Guide on omv-extras.org specifically instructs to use this image (Under Prerequisites > Important Release Note) to be in accordance with the guide, and the script which is used later on during the guide.
So what should I do, go with RPi imager, or the image specified in the guide?
-
Yes there was a recent thread about using that particular image, as the RPi imager can be installed on Linux you could try that and see if there is an option/way to select that downloaded image, or install Balena Etcher and use that to write the image, but to do that you may have to create an ssh file
-
install Balena Etcher and use that to write the image,
I know my way around etcher and have used it countless times. I shall use the image mentioned in the guide (as I did the last time) and Etcher then.
Will report back shortly.
-
RPi imager allows you to choose an image previously downloaded to your PC. Then you can use RPi imager and guide image. Furthermore, RPi imager will allow you to pre-configure SSH access before burning the card.
-
both drives start making a clicking / beeping sound in a tick-tock way
Haven't read the whole thread yet but this is typical under-power.
Tomorrow, I'll read this better and give a better answer.
-
+ 1 had the same problem: under-power. Strange things happen then.
-
I had the same problem. Either drive would work by itself, but not when plugged in together. Solved my problem with a powered usb port.
-
Haven't read the whole thread yet but this is typical under-power.
That turned out to be the case at the end.
-
TakerTX
Hat das Label gelöst hinzugefügt.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!