Wireguard additional parameters in config

MarcS · 31. Januar 2023

Is it possible to add additional parameters to a config via the Plugin?

e.g.

AllowedIPs = 0.0.0.0/0, ::/0

This would route all traffic through the WG tunnel.

ryecoaaron · 31. Januar 2023

Zitat von MarcS

Is it possible to add additional parameters to a config via the Plugin?

It is already adding that line (minus the ipv6) if you leave the Restrict checkbox unchecked in the client config. I assume you are just asking for the ipv6 portion?

MarcS · 1. Februar 2023

So just to be clear: if the Restrict box is ticked, then ALL routing does not go through WG.

And if box un-ticked, then ALL routing will go through WG?

(I dont need ipv6.)

ryecoaaron · 1. Februar 2023

If you tick the box, allowed ips are just the tunnel's ips. If you unticked, you get the line you were asking for.

Jetzt mitmachen!