Setup:
- OMV Server = GIGABYTE H610I DDR4 /w Intel GbE Motherboard (Plugged into the Netgear Mesh Extender)
- NETGEAR Dual-band WiFi 6 Mesh Extender, 1.8Gbps with (4) 1 Gig Ethernet Ports (OMV Server and Personal computer are plugged into one of these ports)
- Personal Computer = Asus Prime Z390-A, motherboard /w Intel I219-V Gigabit LAN connected at 1 Gig at FULL DUPLEX to a port on the Netgear Dual Band Mesh Extender
Problem:
- OMV Server port speed indicator is orange (when it should be green) indicating its connected at 100 Mbps. Green is 1 Gig
- The OMV Diagnostics below indicates its configured for 1 Gig full duplex
- There is a discrepancy between the hardware and software speed and duplex setting that's being reported.
Hep Request:
- Help me understand what is going on. If not know, then
- Help me manually configure the ethernet speed and full duplex in OMV 6.
OMV Diagnostic Report:
= Network interfaces
================================================================================
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eno1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
link/ether d8:5e:d3:da:26:98 brd ff:ff:ff:ff:ff:ff
altname enp0s31f6
inet 192.168.55.60/24 brd 192.168.55.255 scope global eno1
valid_lft forever preferred_lft forever
3: docker0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN group default
link/ether 02:42:0c:c2:6d:e7 brd ff:ff:ff:ff:ff:ff
inet 172.17.0.1/16 brd 172.17.255.255 scope global docker0
valid_lft forever preferred_lft forever
--------------------------------------------------------------------------------
Interface information eno1:
===========================
Settings for eno1:
Supported ports: [ TP ]
Supported link modes:
10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes:
10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Auto-negotiation: on
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
MDI-X: on (auto)
Supports Wake-on: pumbg
Wake-on: g Current message level: 0x00000007 (7) drv probe link
Link detected: yes