Ip adress not working for web interface

what is your NAS IP?.

en other computer in explorer use http://yourNASIP to log in OMV .

if is your first time user is admin and password is openmediavault, try to change to not use default values.

127.0.0.1 is local loopback, not a lan ip. enp 1 an 3 are yot wired lan connections, and wlp is wireless.

none are configured.

use omv-firstaid and configure a connection

First of all are you cable connected to your LAN? You need that done.

As for walking you through it, I can't do it completely as I can't interrupt the connection to my system, but basically you want to:

configure network interface

pick the interface you are configuring

configure ipv4 but don't configure ipv6

and for simplicity, I would recommend that you use dhcp.

It isn't much more complicated than that unless you are trying to set a static ip, in which case you have to specify it, and you will also have to add dns servers and gateway ip's.

If it works uding dhcp you can go back and set static settings, or you can make a reservation in your router that will always give that nic the same ip.

no worries. And for the sake of clarity, when you get it connected, it serves out a web page to that ip address, so you need to use another system with a web browser to get at the interface.

The default login will be

user: admin

pw: openmediavault

Quote from FlamingAirplane

As for everything else I realize that I have been just doing the default of what the setup selects, so I will try the steps you listed above to see if it works

Thank you for helping me in your spare time

Also, the default will enable dhcp, so you should be good once you have a cable in place. The default will not configure wireless.