Beiträge von matefon

    How can I change tun0 to tun1 for example?

    I think that's the problem, because a tun0 device already exists.

    Code
    Sat Apr 18 07:18:52 2020 TUN/TAP device tun0 opened,
    Sat Apr 18 07:18:52 2020 TUN/TAP TX queue length set to 100,
    Sat Apr 18 07:18:52 2020 /sbin/ip link set dev tun0 up mtu 1500,
    Sat Apr 18 07:18:52 2020 /sbin/ip addr add dev tun0 local 10.10.1.146 peer 10.10.1.145,
    Sat Apr 18 07:18:52 2020 /etc/openvpn/tunnelUp.sh tun0 1500 1553 10.10.1.146 10.10.1.145 init,
    Up script executed with tun0 1500 1553 10.10.1.146 10.10.1.145 init,
    Updating TRANSMISSION_BIND_ADDRESS_IPV4 to the ip of tun0 : 10.10.1.146,

    Yes, and sorry for the late answer, I wasn't at home.

    Log in Portainer:

    I'm using a VPN server to reach my server from outside.

    And I wanna use a VPN client (Transmission-Vpn) to hide ip, because I'm downloading and seeding torrents.

    The point is I don't want to use VPN client for everything, just for Transmission BT.

    VPN is running outside Docker, I use it to access my server from the internet without port forwarding (some security alertness).

    Usually nothing is connected to the VPN unless I'm not at home and configuring anything or using SMB.

    Hello there,


    I'm struggling with transmission with vpn container in Docker (Raspberry Pi 4).

    I pulled

    jstrader/transmission-openvpn:latest

    And confiigured like shown in this and this video. (In Portainer, so I couldn't add these:

    Code
    --network=mynet
                   -p 9091:9091 
    Extra arguments for special problems
      --dns 8.8.8.8 --dns 8.8.4.4
      --sysctl net.ipv6.conf.all.disable_ipv6=0 
      OPENVPN_CONFIG=CA\ Toronto

    Also added --cap-add=NET_ADMIN -d by checking it in Portainer.

    But when I run the container, the output is this: :(


    Could someone help me?


    Bests,

    Matt

    After a restart, none of my things worked.

    I checked /sharedfolders and there was just my internal SD folders.

    So, I opened /etc/fstab again, copied the openmediavault rule and added it to /sharedfolders too.

    After a restart, it works.

    Plex, and mount, and my webserver.

    Thread resolved.

    Hello there,


    I installed Plex Media Server in Docker (on a Raspberry Pi 4) with the help of TechnoDadLife's video.

    Everything is fine on my local network. I even reach config panel (my.dns.name:32400) through my DNS. But when I start playing any video with even 480p (tried both on my local network through Dns and on 4G with my phone), an error shows:

    Conversion failed. The transcoder exited due to an error.

    after loading a lot or after I fast-forward into the video.


    Please help, I didn't find any solution yet. :(


    Bests,

    Matt

    Yeah...

    And it is after an hour or so, but not immediately.

    For example, when I waked my PC up the connection was slow but now: