Beiträge von kamzata

Zitat von richrt

I think I found the solution, but not sure if it works in all of your scenario.

So after installed OMV5 with OMV extras, install Docker; Portainer; Cockpit.

Next I've added HassOS KVM VM in Cockpit as a new VM.

Next in OMV5 WebUI go to Network settings and fisrt delete my Interface : enp4s0

After I added a new Bridge, with name: Bridge, and attached the enp4s0 interface to bridge.

Next I set the same static IP address, as it had before with the normal interface. Till that point I didn't Save the OMV5 config chages!!!

After Save to full configuration changes in OMV5, so you will lose the connection only for 2-5 pings.

Finally I've set the existing HassOS VM the following in Network settings: Direct connection; Model type: e1000; br0

In the end of the story, I get a valid LAN DHCP IP address to my HassOS VM, and reachable by local clients.

Alles anzeigen

I cannot select Direct Attachment, it's grayed out as the other options except for Virtual Network.

I've just installed OMV5, Cockpit, and Proxmox Backup Server (PBS) as Virtual Machine on it. They all work fine but I cannot configure Cockpit network to bridge with my physical card. I tried to select the right network type but "Bridge to LAN is grayed out:

How can I solve?