Posts by dilino

  • 2.5gb interface not detected

    Same issue here. After installing OMV8 on Raspberry Pi 5 (Trixie) the USB network adapters are not properly visible in the OMV UI.


    I noticed that:

    a) before OMV8 installation the adapters are detected as eth1, eth2 and after OMV8 install, they are detected as enu1u3, enu1u4 (running ip a)

    b) OMV8 UI does sometimes list the adapters enu1u3, enu1u4 but they are identified as Bonds, not Ethernet.

    c) After deleting the adapters enu1u3, enu1u4 in the UI (without accepting changes), they are no longer visible in as availble on the Bridge screen.

    d) After restart, the adapters enu1u3, enu1u4 are no longer visible even using omv-firstaid, the only way to get them back to re-run the omv install script


    Up until now, I ran OMV7 on a Raspberry Pi 5. I use the Pi as a 2.5Gbps network switch using two USB 2.5G network adapters and bridging them with the built in one. Unbelieveably all works fine and I get 260MB transfer speeds.


    Attaching the diagnostic report.