It is one on the motherboard and one into the pci.
The one in the pci is Realtek RTL8169, and the motherboard is in a IBM computer type 8143-23G.
Is the name Enp10s12 the name of the network card in omv??
Posts by audi30tdi
-
-
-
Now I have run
apt-get update && apt-get dist-upgrade
apt-get install firmware-realtek
apt-get install net-Tools
omv-initsystem
but it is still no Interface in the list, and if I wan't to add one it is only one "Enp10s12" to choose.
Any other solution to try??
-
Ok, missing the "get" I. I run this command, and after I tried the omv-initsystem again, but the same error is showing;
W:Possible missing firmware /lib/firmware/rtl_nic/rtl..................for module r8169
-
Ok, but when I wrote apt-update && apt-get dist-upgrade after I have logged in, I only got an error saying; apt-update: command not found
Why??
And is it correct that the user I have logged into is root@Debian??
-
Will try that, but have Debian installed and then omv into Debian. Try to login through SSH from a computer, and it looks like I get into Debian not OMV.
How can I get into the OMV With SSH from an another computer??
-
When I run omv-initsystem, I got a lot of lines With W:Possible missing firmware /lib/firmware/rtl_nic/rtl..................for module r8169
Could that be the reason that I don't have any Interfaces in the list??
-
This report??
-
Hello!
Have installed omv 4.x on a computer With 2 nic, but under network and Interfaces, there is none!! The network is working fine, but why is it not showing in the list?? And therefor I can't setup bonding either.
Can it be because I have installed omv on Debian?? If so how do I solve setting up bonding??
Regards
Kåre! -
Hello!
Do I have to set priviliges/ACL to every user/Group included them With no access, or can I just set it for the person which shall have read/Write or read-only??
Regards
Kåre! -
Ok, but have read in some other post that I must only use Priviliges and not the ACL?? What is the difference and when sould I use ACL and when to use the priviliges??
-
Hello!
Have set up an omv With 30 Directory, and have 38 users which I shall give different priviliges. Can I define Group and give only the Group priviliges to each Directory, or must I also give the user priviliges??
Regards
Kåre! -
Hello!
Is the only way of backup configuration to install Clonezilla??
Have a system running today With OMV 1.x and are setting up a New one With 3.x, do I have to set up everything manually like user, Groups, shared folders etc. Or is it a easier way??
Regards
Kåre! -
I only get filename or Directory not excists when I try in Debian 8.9
"deb packages.openmediavault.org/Public Erasmus main" > /etc/apt/Sources.list.d/openmediavault.list
-
Thanks!!
Which code must I use to install OMV on Debian??
Have tried; echo "deb http://packages.openmediavault.org/public stoneburner main" > /etc/apt/sources.list.d/openmediavault.list
but don't work....................
-
Hello!
Which Version do I have to install of Debian to get OMV work on a 32bits computer?? Have tried Debian 9.1 but can't install OMV.
If I have to use Debian 8.x, where can I download that from??
Regards
Kåre! -
The output of ip addr is;
1: lo <LOOPBACK, UP, LOWER_UP> mtu 65536.................
2: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN Group default qlen 1000
link/ether 00:08:a1:c5:d6:a6 brd ff:ff:ff:ff:ff:ff -
Yes, have tried a 64-bits Version and won't install. have to old computer for that Version..........
Isn't it any solution, or workaround for this error??
-
Hello!
I just installed 3.0.36 i386 Version, that was the newest Version for i386 I found. Everything goes ok during installation, restart computer and login on console. But it don't show any ipadress, so I run omv-firstaid, and configure the network manually.
And after answer NO to enabled WOL, I got an error:address6: the value ' ' is not a string.
And the ip I set was not saved, as I can't Connect to that ip. How can I resolve this??
Regards
Kåre! -
Could it be something about the dns server on the omv?? I know the ipadr is correct, because I have set the ip on the router myself, and it Works on every computer on my net!
But if I try to ping http://www.Audi.com, or ping Audi.com, it fails. But if I ping 8.8.8.8, or the ip to Audi.com (104.76.27.8) I get result