I finally resolved this issue.
If you're reading this thread for this solution, then use the above script and modify the ethernet adapters accordingly.
Next store it in any directory, and use the cron to schedule it at reboot/hibernation resume.
I just got the OMV installation done in the GCP VM.
It requires a lot of work to do for networking and security, which I'm new to this.
My server is still working great in the past years.
I'm not sure about this cloud route yet.
I'm been using OMV more than 7 years, and really like the system and the community.
Lately, I'm thinking should I migrate my system to the cloud to save resources and power consumption.
Please share your thoughts.
I'm currently testing out Windows 10 via Cockpit.
I'm using Vbox for other VMS.
But thanks for sharing the advices.
I take a look later.
I'm try to connect to the VM via RDP.
I've tried: Bridge to LAN, and direct attachment, but still can't connect via RDP.
I can only connect to it via the console.
where do I find its dir to remove it ?
I like Intel NICs too, but so far the computer shut down itself after it wakes up from hibernation.
error: e10000e hardware unit changed
I couldn't find the solution for it.
After I did some research, I cancelled my Realtek NICS and order a newer model…
I'm currently using a custom built for OMV5, but lately it has some ethernet driver issue.
I'm thinking if I can't fix this issue or the system board is dead in the future, then I need a new system.
Is anybody in here able to install OMV5 in…
Apparently the error persist after the server woke up from hibernation.
I'm planning to put the script to disable tso and gso like this format.
I'm not sure if this work in OMV5: RE: Customize /etc/network/interfaces the OMV way [>= 1.11]
Update 1: I put…
I'm not sure if this issue is only affect my system.
But it annoying as crap.
The computer boot up and showed error for: e1000e 0000:00:19.0 eno1
I've tried this solution https://unix.stackexchange.com…ic-and-hardware-unit-hang but error persist after…
Thanks for sharing the guide.
I managed to installed Windows 10.
However, I'm tried to create a bridge adapter, but received an error.
Note: I'm currently using a bond0 in OMV.
(Code, 56 lines)
I just replaced a bad hdd with a new hard drive.
My setup: LUKS Encryption with SnapRAID.
I unmounted the bad hdd from the encryption but it showing missing.
It let me did the encryption first time for the new hdd but it failed to create a new file…