Sorry, my previous post was print from WebUI
In Storage > File System is only show the system disk ... RAID5 disks not.
in Storage > RAID is show only the RAID system /dev/md0
Because I am not the RAID disk list in the Storage > File System !!!
Beiträge von AleMagna
-
-
This only:
Version : 1.2
Creation Time : Fri Jan 13 17:07:38 2017
Raid Level : raid5
Array Size : 3906766848 (3725.78 GiB 4000.53 GB)
Used Dev Size : 1953383424 (1862.89 GiB 2000.26 GB)
Raid Devices : 3
Total Devices : 3
Persistence : Superblock is persistentIntent Bitmap : Internal
Update Time : Sun Jan 15 20:19:11 2017
State : clean
Active Devices : 3
Working Devices : 3
Failed Devices : 0
Spare Devices : 0Layout : left-symmetric
Chunk Size : 512KName : openmediavault:Store (local to host openmediavault)
UUID : 4227c21a:da47733c:c2921908:0aabd159
Events : 2502Number Major Minor RaidDevice State
0 8 0 0 active sync /dev/sda
1 8 16 1 active sync /dev/sdb
2 8 32 2 active sync /dev/sdcbut do not show the partition detail ... How do I know when I formatted discs what fs I used?
-
in WebUI I looking for the information but I don't try it.
Can help me and you tell me where I looking for ... -
I can not find out what the disk partition of my RAID5 array OMV.
Is there a command or a file where I can find out what.
Thanks in advance.
Alex -
OK,
but would be sufficient that in Network > Interfaces selecting "wlan0" then Modify and in box "Advanced Settings" next input box "Option" there was another input box, for example "Other Command", in which to write command append to.It's possible?
Otherwise, how can I do it? -
Sorry another problems
I reconfigured the network on OVM server from WebGUI and now the wireless card is not activated when I start the server.
In my manual configuration instead everything was ok.
The difference between my manual configuration and the OWM is the lack in the file /etc/network/interfaces of this line:wpa-driver wext command
wpa-conf /etc/wpa_supplicant.confHow can I do?
-
Ooooops ... ok
-
What hardware?
WiFi and other interfaces not up during installation and setup OMV phase
-
thanks you, I was able to upgrade Linux kernel to 4.7 and install the wireless drivers but the wireless setup I had to do by hand. There is a plugin to configure the pc hardware remotely?
-
I just installed openmediavault 3.0.36 amd64 on an SSD and 3HD configured as RAID5, everything works fine. I need to enable WiFi on motherboard and I need the 4.6 kernel on this Debian backport. Already tested with Debian Jessie installation and it works fine, I can also do it with OMV?