Posts by thewer

    Hi there,


    I have a problem with the Syncthing plugin where it stops my harddrive from spinning down as long as Syncthing is running.


    My workaround for now would be to schedule the Syncthing plugin (the service/user I added in the plugin settings) to run only eg between 2-8pm.
    Then the hdd would keep spinning only during these times.


    Does anybody know the command line to use in the schedule settings (I'm not sure if this is something that can be found in the official Syncthing documentation as I imagine a plugin might work differently).


    Thanks a lot in advance :)

    I really don't know much about Btrfs, but I would guess sdb, sdc and sdd all have the same UUID, only different UUID_SUBs…
    OMV sees them as a single pool with a single label and cannot mount them to the default address because sdc is already mounted there or because sdb can't...


    I think running blkid before creating the pool gives them unique UUIDs? Or unmounting sdb and mounting of them?

    Ok… managed to figure it out myself...
    Here's how to make OMV work with veracrypt (short version, new install… new empty drive):


    - enable ssh
    - ssh as root into OMV(Debian)
    - gpart the attached hard drive (eg sda) with a single partition, here sda1 (or two or three... ),
    - install veracrypt under debian (tutorials for rpi should help, I downloaded a *. deb file for armhf -using an Odroid myself - here https://software.opensuse.org/…racrypt&package=veracrypt )
    - encrypt the new partition (sda1)
    - in case the new partition hasn't got a label… label it with eg e2label (if it is ext4)… eg 'Data'
    - mkdir /srv/dev-disk-by-label-Data (if label is Data)
    - mount sda1 to /srv/dev-disk-by-label-Data


    Now everything should show up under devices
    (one additional step I did was manually entering the mntent section in the OMV config.xml… but I think that's not needed).

    Hi there,


    I'm currently setting up OMV on an Odroid HC2.


    However I have problems sharing a folder as the devices list doesn't show my drive (or anything).
    Does anyone know what OMV is looking for when identifying devices?


    For the record, part of the problem might be the drive encryption. I did NOT use the Luks plugin, as Luks uses base64 encoding, that would effectively reduce my 4tb drive to 3tb.


    Hence I instead (not in OMV but ssh to Debian)
    - gparted the attached hard drive with a single partition,
    - installed veracrypt under debian, encrypted the partition and mounted it.


    Everything shows in OMV under file systems:
    - the sd card partitions with OMV
    - sda1 partition is there… not mounted (ok as encrypted)
    - veracrypt mount is there, too - as device 'dev/mapper/veracrypt1'… label 'Data' and mounted under /media/veracrypt1


    So what do I have to do to get the encrypted partition found as device in shared folders (if file systems clearly sees it)?


    Different mount point? Label?


    Thanks a lot for you help :)