The strange thing is, that i cannot see a multipath.conf at /etc. I just have /etc/multipath/bindings and /etc/multipath/wwids
Beiträge von timmekk
-
-
multipath tools are already installed. output of multipath -ll:
root@OMV-NAS:~# multipath -ll
360050763008083103800000000000026 dm-4 IBM,2145
size=5.0T features='4 queue_if_no_path retain_attached_hw_handler queue_mode mq' hwhandler='0' wp=rw
|-+- policy='service-time 0' prio=50 status=active
| `- 5:0:0:0 sdb 8:16 active ready running
`-+- policy='service-time 0' prio=10 status=enabled
`- 12:0:0:0 sdd 8:48 active ready running
360050763008083103800000000000025 dm-5 IBM,2145
size=7.0T features='4 queue_if_no_path retain_attached_hw_handler queue_mode mq' hwhandler='0' wp=rw
|-+- policy='service-time 0' prio=50 status=active
| `- 12:0:0:1 sde 8:64 active ready running
`-+- policy='service-time 0' prio=10 status=enabled
`- 5:0:0:1 sdc 8:32 active ready running
36b083fe0ebd92400244981d22aec171c dm-0 DELL,PERC H730 Mini
size=279G features='3 retain_attached_hw_handler queue_mode mq' hwhandler='0' wp=rw
`-+- policy='service-time 0' prio=1 status=active
`- 0:2:0:0 sda 8:0 active ready running -
Hi all,
I have set up new OMV Server on a Dell Poweredge Server Hardware wirth a Fibrechannel HBA and connected two IBM 3700 SAN Controller to it. I set up everything in debian and can see the configured disks in OMV but it is showning the disks twice, at it will not use the multipath driver. I use an Emulex HBA. Is there anything I am doing wrong?
attached you will find output in console of harddisks.
-
is there any news on the fix for that? I have the same problem and just want to use OMV.