Thanks again. All done. I'll mark this as solved.
Beiträge von Borat
-
-
I have this sorted now (I think). I added the SSH rule from your example including the uuid, saved the file and rebooted. I no longer have the "Apply" section at the top of the screen and no error appearing. I can ssh into the server also. However the boot log is still showing this:
CodeThu Nov 14 21:59:35 2013: Setting up networking.... Thu Nov 14 21:59:35 2013: Configuring network interfaces.../etc/network/if-pre-up.d/iptables: 7: -A: not found Thu Nov 14 21:59:35 2013: /etc/network/if-pre-up.d/iptables: 7: -A: not found Thu Nov 14 21:59:35 2013: SIOCSIFADDR: File exists Thu Nov 14 21:59:35 2013: Failed to bring up lo. Thu Nov 14 21:59:35 2013: /etc/network/if-pre-up.d/iptables: 7: -A: not found Thu Nov 14 21:59:37 2013: /etc/network/if-pre-up.d/iptables: 7: -A: not found Thu Nov 14 21:59:38 2013: done.Code
Alles anzeigenroot@openmediavault:~# ifconfig eth0 Link encap:Ethernet HWaddr a0:b3:cc:df:1c:5a inet addr:192.168.1.100 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:5825 errors:0 dropped:294 overruns:0 frame:0 TX packets:3501 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:4790814 (4.5 MiB) TX bytes:2739871 (2.6 MiB) Interrupt:18 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:111 errors:0 dropped:0 overruns:0 frame:0 TX packets:111 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:36016 (35.1 KiB) TX bytes:36016 (35.1 KiB)Could you advise if this thread can be closed or if the above log section highlights an issue still to be fixed?
Thanks very much for your help.
-
Sorry for the delay in getting back. A long day at work.
Code
Alles anzeigen<iptables> <!-- <rule> <uuid>xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx</uuid> <family>inet|inet6</family> <rulenum>1...x</rulenum> <chain>INPUT|OUTPUT</chain> <action>ACCEPT|REJECT|DROP|LOG</action> <source>[!]?xxx.xxx.xxx.xxx|[!]?xxx.xxx.xxx.xxx/xx|xxx.xxx.xxx.xxx-yyy.yyy.yyy.yyy</source> <sport>xxx|xxx-yyy</sport> <destination>[!]?xxx.xxx.xxx.xxx|[!]?xxx.xxx.xxx.xxx/xx|xxx.xxx.xxx.xxx-yyy.yyy.yyy.yyy</des tination> <dport>xxx|xxx-yyy</dport> <protocol>[!]?(tcp|udp|icmp)|all</protocol> <extraoptions>xxx</extraoptions> <comment>xxx</comment> </rule> --> <rule></rule> <rule></rule> </iptables> -
I have done all updates already. The ssh problem has existed from the moment I installed OMV.
When I click Apply I get the error above. The warning never disappears. Every time I Apply the error shows.
-
I'm running openmediavault_0.5.20. I have two big problems with it so far. First of all SSH does not start (at boot) most times even though it's enabled in the services. It shows a green indicator for "enabled" but grey for "running". I have to physically attach to the server and
Code/etc/init.d/ssh startThis works until the next boot.
The 2nd problem occurred after I enabled Squeeze backports to get Kernel 3.2.0-0.bpo.4-amd64 #1 SMP Debian 3.2.46-1+deb7u1~bpo60+1. I needed this to use my RocketRAID 2720SGL card. Anyway, after installing build-essential and the kernel (+headers) I have the card working. I did an apt-get upgrade and that's when I noticed this message at the top of the screen. "The configuration has been changed. You must apply the change". After I click Apply I get this
Code
Alles anzeigenFailed to execute command '/etc/network/if-pre-up.d/iptables 2>&1': /etc/network/if-pre-up.d/iptables: 7: -A: not found /etc/network/if-pre-up.d/iptables: 8: -A: not found Error #4000: exception 'OMVException' with message 'Failed to execute command '/etc/network/if-pre-up.d/iptables 2>&1': /etc/network/if-pre-up.d/iptables: 7: -A: not found /etc/network/if-pre-up.d/iptables: 8: -A: not found' in /usr/share/openmediavault/engined/module/iptables.inc:53 Stack trace: #0 /usr/share/openmediavault/engined/rpc/config.inc(194): OMVModuleIptables->startService() #1 [internal function]: OMVRpcServiceConfig->applyChanges(Array, Array) #2 /usr/share/php/openmediavault/rpcservice.inc(125): call_user_func_array(Array, Array) #3 /usr/share/openmediavault/engined/rpc/config.inc(243): OMVRpcServiceAbstract->callMethod('applyChanges', Array, Array) #4 [internal function]: OMVRpcServiceConfig->applyChangesBg(Array, Array) #5 /usr/share/php/openmediavault/rpcservice.inc(125): call_user_func_array(Array, Array) #6 /usr/share/php/openmediavault/rpc.inc(62): OMVRpcServiceAbstract->callMethod('applyChangesBg', Array, Array) #7 /usr/sbin/omv-engined(495): OMVRpc::exec('Config', 'applyChangesBg', Array, Array, 1) #8 {main}Coderoot@openmediavault:~# cat /etc/network/if-pre-up.d/iptables #!/bin/sh # ifpreup hook script for iptables # Generated by OpenMediaVault iptables -t filter -F ip6tables -t filter -F -A -p -j -A -p -jAny help appreciated.