Beiträge von TheRunningOtaku

I did, actually. The problem was that the OS was being written into the installation USB drive.

Thanks for the help!

Update:
The OS was being installed into the wrong drive - even though I selected sdb, it was installing in sda, (the original USB drive). Fixed the problem by using a USB optical drive instead.

Nevermind, rebooted and the drives were registered and everything worked fine. Sorry for the spam!

Hey,
Recently my boot drive for OMV box died (OMV 1.0.2) so I reinstalled OMV (This time OMV 1.9)
However, now I found that the old RAID is no longer available in the system. How can I recover it?
The new server works fine, just that I cannot see my old RAID config. I still have the two drives that have not been changed in any way - just that they are seen as Physical disks (Two WD Reds), but without the option to create any RAIDs or File systems with them.

Thanks in advance for the help!

Hey! Thanks for the quick reply.
After all that, I have the feeling that I may have installed OMV onto the wrong drive - let me go back make sure that it's installed on the correct drive before I do anything else. (I thought of it after you said that it should at least boot). Will let you know if that's the problem.

Thanks again for the help!

Hey guys,

Just installed a clean install of OMV 1.9 on a 2GB USB flash drive. The install went without a hitch, but when I went to boot, all I can see is a blinking cursor on the top of the screen. This has been tested with and without any other drives in the system, and the mobo has no trouble at all registering the USB drive.

I have not seen anything other than the blinking cursor - no GRUB, nothing at all.
The Web interface also does not show up at all.
I am using an Asrock AM1-B Motherboard with 2GB of DDR3-1066 RAM (been through Memtest) and a Sempron 2650.
I have already cleared the CMOS, and I have already checked that everything is plugged in properly.
The computer was able to run Memtest and the install without a problem, so I don't think that's the issue.

Does anyone have any suggestions?