Fixed in openmediavault 3.0.27, see <a href="https://github.com/openmediavault/openmediavault/commit/b1b77e852c8b01154aaa57fcb15af30ecd78e601" class="externalURL" rel="nofollow" target="_blank">github.com/openmediavault/open…54aaa57fcb15af30ecd78e601</a>
Kinda new in the OMV, but how to apply this fix?
Hey,
After fully configuration the OMV and working with it ( no problems at all ),
The interface of Network cards when editing my Bond is not showing, just keeps on Loading untill i receive Bad Getaway error,
The 2nd configuration of single line is working fine and loading fine.
The configuration is -
1 - Bond, eth1&2
2 - eth0
both are static IP, and are working, but i cannot see them.
I attached a screenshot of the problem,
Thanks
Are you sure the flash drive is good? A lot of times on stuff like this, it's a flaky flash drive causing the issue.
Well seems that the USB gone bad,
Thanks
After some Grub re installation i was able to pass the Symbol error,
Now i am stuck at "Uncompression error" System Halted
any idea? i ran Memtest and it pass'ed fine
Hey guys,
I am new to the Linux/Debian world so be easy on me,
After installing and working normally on my NAS it wont start up. The OMW is installed on a USB Stick,
There is an error Symbol not found: 'Grub_er0no*C?ub_?allot{'.
I tried to run Super Grub2 from an USB and when choosing the partition with the OS it would give me an error "UnCompression error" System Halted,
then i tried with Boot-Repair-disk, and received "please enable a repository contacting the [Grub2] packages in software sorces of Debian/Linux(sde1), then try again.
and i have no idea how to Enable it, even with some google i didn't find an answer,
Any help will be welcomed,
Thanks.
