Dashboard

Thanks again for this you two. Keep up the great work!

Ryecoaaron, what does the test button do? I clicked it and it seemed to have crashed my Docker session. I just want to make sure it’s working and maximizing the NVMe lifespan.

ok, i am just used to other systems where it would see a degraded raid after reboot and ask to get a new drive. Wasnt expecting that it does not even see the raid at all. Especially when only one out of 6 drives got swapped.
But good to know. At least i…

Fixed.
After reading logs and with the help of AI all I need to do was run "sudo apt install proftpd-mod-crypto"

This is no bug, this is how mdadm works. You can try to add the new disk as hotspare before removing the disk that is to be replaced. To keep it short, the mdadm support in OMV does not do any magic for you.

Hello everyone.
I am in the process of making my raid bigger while.keeping the data, so i replace all my 1 tb drives one by one with 3 tb drives and rebuild the degraded raid. But to do so i always have to stop my md127 mdadm and restart in the console…

votdev
Thank's for your great work on this project!

[…]

If you attempt it, you'd be well served by cloning your boot drive, testing the clone, then running the upgrade attempt on the clone. As gderf has indicated, there's a good chance the process will fail. With that many upgrades, I'd put the chance…

[…]

Yes

Thanks. Was thinking the same and I will try macvlan and see how it goes.

I think it is strange that the default container setup for homeassistant creates this duplicate mDNS config.

votdev
Will it be fixed with 7.7.25?

Thank's
and best regards
prtigger