Hi All,
I have noticed since I have started to upload more files to my file server that the speeds for writing are very low.
I have several SMB shares set-up and these seem to be very slow
I have a 1g Network card and GB network Switch that shows I'm connected at 1GB. Though my speeds are as follows
Wireless Write speed 4.7Mbps read speed 25Mbps
Cables Write Speed 28Mbps and read speed is 359Mbps
AS you can se the write speed is very low. I have following outputs
root@snowdon:~# ethtool eth1
Settings for eth1:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Link partner advertised pause frame use: Symmetric
Link partner advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes
root@snowdon:~#