Hi Everyone,
I am very new to OMV. I was running an smb server off my dd-wrt router and wasn't satisfied with the speeds so I bought a banana pi and am now running OMV with a usb attached 1.5tb hdd.
The problem I'm encountering is that when I start up OMV, it hangs and I see the red light on the hdd go on non-stop. SMART analysis is showing a failure on the hdd, could that be hanging the system?
If I disconnect the hdd, OMV starts up no problem. I can then reconnect the hdd and it seems to work ok (although my network speeds are worse than they were with the dd-wrt setup...)
If you would like me to print output from the OMV, could you please direct me on how I do that? I'm assuming I just copy from the OMV gui and then place it in the source option in this forum....
Many thanks!