So, I have a 7 disk array in RAID5. One of those was a hot spare. I had a disk fail. When I went to remove it from the array, the array did not rebuild itself as I had a failed spare as well. I turned the NAS off and went through until I had found the correct drives that needed to be replaced. I made sure everything was back in place and rebooted. One of my good disks was not detected in the reboot, and so the RAID array was not there. I shut it back down and reconnected everything once again. All of my disks are being read now, including the two failed drives. Can I be helped when my extra drive comes in? Or did I basically have a 3 disk failure in RAID5 and all hope is lost? I don't have a backup..
At least 2 Disk Failed in RAID5. HELP!
-
- OMV 2.x
- johndoe86x
-
-
Since you had 1 drive fail and your hot spare was also a failed drive, you have lost all of your data most cetainly.
-
Since you had 1 drive fail and your hot spare was also a failed drive, you have lost all of your data most cetainly.
That's certainly my fear. However, nothing was apparently wrong up until I rebooted with a loose connection on my good drive. I'm hoping someone can show me some command line magic.
-
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!