hello everyone, i'm trying to see which network interfaces I have, and from system -> network -> interfaces I can see no cards.
I have 2 NICs and, of course, I can set them up from CLI.
Any ideas?
GUI - No network interfaces
-
- OMV 4.x
- ignacio97
-
-
Did you try adding one?
-
Thanks for your message ryecoaaron.
Yes, I've tried adding one, but I receive this message: Failed to execute command 'export PATH=/bin:/sbin:/usr/bin:/usr/sbin:/usr/local/bin:/usr/local/sbin; export LANG=C; monit monitor collectd 2>&1' with exit code '1': Cannot create socket to [localhost]:2812 -- Connection refused -
collectd doesn't seem to like your NICs. What kind of NICs?
-
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 0c)
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 06)One onboard, the other one, PCI Express
-
Those should have been detected when installing unless you didn't have the network connected. Try omv-firstaid
-
I've removed the pic express card...
then, I've tried to change the nic parameters via gui, and, yes, I can see the changes (cat /etc/network/interfaces) but into the gui I get this message:communication failure
communication failuredo you know why this is happen?
-
I reponse myself... I suppouse that I'm receiving this msg due to I no longer have this IP...
-
do you know why this is happen?
The network restarting can cause this and as you found, if the system changes IP address, it will keep happening
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!