hello everyone, i'm trying to see which network interfaces I have, and from system -> network -> interfaces I can see no cards.
I have 2 NICs and, of course, I can set them up from CLI.
Any ideas?
GUI - No network interfaces
-
- OMV 4.x
- ignacio97
-
-
Did you try adding one?
-
Thanks for your message ryecoaaron.
Yes, I've tried adding one, but I receive this message: Failed to execute command 'export PATH=/bin:/sbin:/usr/bin:/usr/sbin:/usr/local/bin:/usr/local/sbin; export LANG=C; monit monitor collectd 2>&1' with exit code '1': Cannot create socket to [localhost]:2812 -- Connection refused -
-
collectd doesn't seem to like your NICs. What kind of NICs?
-
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 0c)
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 06)One onboard, the other one, PCI Express
-
Those should have been detected when installing unless you didn't have the network connected. Try omv-firstaid
-
-
I've removed the pic express card...
then, I've tried to change the nic parameters via gui, and, yes, I can see the changes (cat /etc/network/interfaces) but into the gui I get this message:communication failure
communication failuredo you know why this is happen?
-
I reponse myself... I suppouse that I'm receiving this msg due to I no longer have this IP...
-
do you know why this is happen?
The network restarting can cause this and as you found, if the system changes IP address, it will keep happening
-
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!