New build will not boot post install

    • OMV 4.x

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • New build will not boot post install

      Hey all,

      I'm in need of a little help here, hoping you guys can help me straighten it out. I've just built up a new system, the install appears to complete successfully with no issues, but after rebooting it appears to freeze, and doesn't do anything. I've tried to install to a onboard ssd, standard 2.5" ssd, and a 2.5" spinning disk. They all act the same. After it get to this point I get a weird beep and that's where it sits. Also for reference I did have FreeNAS running on this system without issue. So I'm a bit stumped as to what the issue could be. Any help would be greatly appreciated.

      Screen shot is attached to the post

      Build is as follows:
      ASROCK B450 PRO4
      AMD Ryzen 3 2200G
      Intel 545s M.2 2280 128GB os drive
      16g RAM
      LSI SAS 9207-8i
      7 4TB WD Red
      1000w gold rated power supply
      Images
      • MV-error2.jpg

        723.85 kB, 3,145×750, viewed 36 times