Hello All,
I would like to install OMV on my new NAS using J3455-ITX.
I need your advice for my first setup.
Do I need to enable/disable specific parameters on BIOS like CSM (Compatibility Support Module) or C0/C1/C6 (power consumption), etc...?
After that I will install OMV 4.1.22 because I would probably like to test plex on my NAS.
Thank you very much for your recommandation.
Best regards,
Damien
J3455-ITX BIOS SETUP
-
-
-
It seems to be recommended to put the BIOS to Legacy mode for OMV install.
I have the Legacy USB Support which is enabled on my side.
I see on some posts that CSM is enabled (by default disabled on my MB). Do I need to enabled it too ?I will let the intel power consumption parameter to C6 which is the value set by default.
Damien
-
Well, actually I've install OMV on the same MB recently. And I can say I didn't change default settings. So if you are worring whether you run into a problems during OMV/Debian installation, you can be pretty sure it won't happen.
I had a problems, but my configuration a bit exotic and moreover I used Debian 10+OMV5, so it was rather because I love challenging projects, not because hardware caused an issues.
-
Hello Errikk,
I install OMV without any issue today.
Thank you for your help !
Damien -
Glad to hear that. Enjoy! )
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!