Beiträge von JonexGame

sudo mdadm --create /dev/md/name /dev/sda1 /dev/sdb1 --level=1 --raid-devices=2

That is the solution. I created a mirror(level=1) RAID from /dev/sda1 to /dev/sda2
Thanks

Zitat von gderf

AFAIK, RAID with USB drives is not supported within the OMV GUI. It may be possible to set it up by hand.

Do you know how to do it? Could you share a link or explain to me please?
Thanks

Hello, I have installed OMV 6 on my Raspberry Pi 4, I have connected 2 HDD via USB 3.0 using ALXUM AX-S300A USB3.0 to SATAIII Dual Bay Docking Station. I am able to see on OpenMediaVault menu my disks but when I try to configure this 2 hdd as a raid I do not see any of this HDD. I have tried configure RAID:

- Before delete data

- Before give it to them format EXT4

- Before mount

- After mount

Any advice? My hdd are 2 Saegate Barracuda 1 Tb

I recomend you to check your ip address on your raspberry and check the port that you have asign.

1st Connect your raspberry to a monitor and then start the raspberry. If anything goes wrong you will have access to commandline.

So write ifconfig and check the ip address

2nd check the port: sudo omv-firstaid them select 2 configure web control panel and you can change it

Now you will be able to connect to your raspberry pi