Hello
I read many threads and messages but I cannot figure a solution to my problem.
I think it's a pretty common trouble so I decided to create this thread (sorry if the solution was already describe on another thread but I didn't find or understand it )
I installed debian jessie on my computer using two hard drives in RAID 1 following this partition scheme:
/
swap
/home
/tmp
Then I installed OVM 3 using command lines. Everything runs well but when I wanted to create a shared folder, I cannot select any volume.
I learned that Openmediavault uses config files to list hardware configuration and that the gui must be used to configure OMV.
Is there a way to make Openmediavault support an existing configuration from previous installation?
(Sorry for my poor english)
Thanks for your work !