hi guys,
hi got this weekend a new UPS the powerwalker VI 1000 lcd.
now i found out that this one is not(yet) supported in the nut plugin i have try'd to do a bit of trouble shooting with no effect
the driver works fine but the device is not found.
this is what i posted yesterday :
hi all.
i recently got a new UPS and you guest it, its a powerwalker same like the one above here.my problem is almost the same and i have try'd to set it up just like the post above me suggestedbut if i do this it states Communications with the UPS ups@localhost cannot be established.i have try'd to use the blazer_usb driver and many more listed in /lib/nut with no success.The same with the port i try'd auto,/dev/ttyS0 also with no success out put of lsusb -v is Source Code
Bus 003 Device 005: ID 0665:5161 Cypress Semiconductor USB to SerialDevice Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 1.10
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 8
idVendor 0x0665 Cypress Semiconductor
idProduct 0x5161 USB to Serial
bcdDevice 0.02
iManufacturer 1 INNO TECH
iProduct 2 USB to Serial
iSerial 0
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 34
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 3 20100813
bmAttributes 0x80
(Bus Powered)
MaxPower 100mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 1
bInterfaceClass 3 Human Interface Device
bInterfaceSubClass 0 No Subclass
bInterfaceProtocol 0 None
iInterface 4 Sample HID
HID Device Descriptor:
bLength 9
bDescriptorType 33
bcdHID 1.00
bCountryCode 0 Not supported
bNumDescriptors 1
bDescriptorType 34 Report
wDescriptorLength 27
Report Descriptors:
** UNAVAILABLE **
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 3
Transfer Type Interrupt
Synch Type None
Usage Type Data
wMaxPacketSize 0x0008 1x 8 bytes
bInterval 1
Device Status: 0x0000
(Bus Powered)
output off upsdrvctl start is Source Code
Network UPS Tools - UPS driver controller 2.6.4
Network UPS Tools - Megatec/Q1 protocol USB driver 0.08 (2.6.4)
No supported UPS detected
Driver failed to start (exit status=1)
any help will be great full gr. steel