I'm upgrading from OMV4 to OMV5. Everything works in OMV4, but when I boot in OMV5 I see the following errors and my USB 3.0 expansion card doesn't work. Does anyone have any suggestions or and i just stuck.
Code
[ 3.280788] DMAR: DRHD: handling fault status reg 2
[ 3.280793] xhci_hcd 0000:04:00.0: WARNING: Host System Error
[ 3.280850] DMAR: [DMA Read] Request device [04:00.0] PASID ffffffff fault addr fffbf000 [fault reason 06] PTE Read access is not set
[ 3.296854] xhci_hcd 0000:04:00.0: Host halt failed, -110
[ 18.712924] xhci_hcd 0000:04:00.0: xHCI host not responding to stop endpoint command.
[ 18.712929] xhci_hcd 0000:04:00.0: USBSTS: HSE EINT
[ 18.728940] xhci_hcd 0000:04:00.0: Host halt failed, -110
[ 18.728943] xhci_hcd 0000:04:00.0: xHCI host controller not responding, assume dead
[ 18.729042] xhci_hcd 0000:04:00.0: HC died; cleaning up
[ 18.729139] xhci_hcd 0000:04:00.0: xHCI host not responding to stop endpoint command.
[ 18.729141] xhci_hcd 0000:04:00.0: USBSTS: HSE EINT
[ 18.745149] xhci_hcd 0000:04:00.0: Host halt failed, -110
[ 18.745180] usb 5-1: USB disconnect, device number 2
[ 18.745182] usb 5-1.4: USB disconnect, device number 3
[ 18.745316] usb 6-3: USB disconnect, device number 2
[ 18.745356] sd 2:0:0:0: [sdc] tag#0 FAILED Result: hostbyte=DID_ERROR driverbyte=DRIVER_OK cmd_age=15s
[ 18.745358] sd 2:0:0:0: [sdc] tag#0 CDB: Read(10) 28 00 00 00 01 08 00 00 01 00
[ 18.745360] blk_update_request: I/O error, dev sdc, sector 2112 op 0x0:(READ) flags 0x80700 phys_seg 1 prio class 0
[ 18.745447] blk_update_request: I/O error, dev sdc, sector 2112 op 0x0:(READ) flags 0x0 phys_seg 1 prio class 0
[ 18.745508] Buffer I/O error on dev sdc1, logical block 8, async page read
Alles anzeigen
Thanks