Fresh Armbian - OMV Install: Default login to Workbench username password incorrect

I'm hoping someone could help me. I just installed OMV6 on Armbian Bullseye for the Odroid HC1 (XU4). I am able to get to the Workbench Webgui but the default login admin/openmediavault produces an error 400 "Incorrect Username or Password". I've tried to use the omv-firstaid to change the admin password with no luck. I'm using a 32gb SD card and it shows plenty of room left, I cleared the cache, used private mode and tried several browsers and even different computers to login to no avail. Does anyone have any other options I can try? Any help would be greatly appreciated.

Robert

Zitat von KM0201

That doesn't really stand up to logic.

Tell me about it.

No no... I totally get it, I'm stumped as well. I just set the password to 12345 and did Control + Shift + R and still nothing. I think I'm going to start fresh and see what happens. I just wasn't sure if there was "one more obscure" thing that I could try that I haven't. I appreciate you even answering my post at all.

Zitat von crashtest

Did you test your SD-card? -> Test.

In any case, try another SD card. They can partially fail (a few blocks go read only). When that happens, bizarre things happen..

I'm going to try this now, seeing I just ran a full reinstall (using the same card) and get the exact same result. I'm guessing it must be the card.

So I'm trying a new SD card just in case, but the original sd card came back without any errors.

So I'm at my wits end. I tried a different 32gb sd card and getting the exact same results. Gui loads up fine but getting error 400 when trying to login with default admin credentials.

So as per usual, it was a user error. I seemed to have downloaded the incorrect Armbian Bullseye image. I've got it working now. Thanks for the help.