Hi, i'm using OMV 1.5.
i'm use two different internet line, but one line is wlan.
before 1 years, i'm not using wlan line... but i want multiple network!
cause plug and setting usb wlan, wlan connect good.
see this.
ZitatAlles anzeigen
eth0 Link encap:Ethernet HWaddr 00:13:77:82:9c:66
inet addr:192.168.0.7 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:82626 errors:0 dropped:0 overruns:0 frame:0
TX packets:104460 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:41023835 (39.1 MiB) TX bytes:114087939 (108.8 MiB)
Interrupt:22 Base address:0xe000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:5728 errors:0 dropped:0 overruns:0 frame:0
TX packets:5728 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:914331 (892.9 KiB) TX bytes:914331 (892.9 KiB)
wlan0 Link encap:Ethernet HWaddr 00:26:66:04:d1:a9
inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3842 errors:0 dropped:0 overruns:0 frame:0
TX packets:7964 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:429176 (419.1 KiB) TX bytes:9044625 (8.6 MiB)
192.168.0.7 -> Existing Line. Nice work.
192.168.1.3 -> Wlan Line. only working in Local Network.
192.168.1.3 is cannot access in outdoor. 0.7 is work good.
192.168.1.3 is can connect only local network...
change DHCP to static, edit port-foward, Twin IP (use real ip. ex. router (real ip) -> PC (192.168.1.3) ==> router (real ip) -> PC (real ip) )... all not work!
i think, it's work on local network... cause maybe, server not allow added ip's Internet packet...?
---add route table
ZitatAlles anzeigen
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
default 192.168.0.1 0.0.0.0 UG 0 0 0 eth0
192.168.0.0 * 255.255.255.0 U 0 0 0 eth0
192.168.1.0 * 255.255.255.0 U 0 0 0 wlan0