Hello
Disclaimer: I know this is not a general Debian forum and I truly spent the last hours (3-6am) searching for a solution and became a personal friend of Clonezilla. Issue is that my search terms are apparently so generic that I end up in “Linux hell”.
Aim:
Run VirtualBox on OMV (it used to work on this machine, not sure what happened ...)
machine
Athlon 200ge on b450 mb
situation
OMV is freshly installed and configured
All works as expected
issue:
I installed OMV - Extras
This added installation of latest BPO (to my understanding needed for VirtualBox) (4.19.)
Booting into the BPO Kernel,I see some lines from the boot process (screen attached to machine directly)
After some seconds, the screen goes blank and all stops
OMV is not reachable via SSH
I cannot see on screen what the last lines are prior to crash
Booting into the stable kernel works, OMV is up
Any advice
1. How I could identify the exact reason for the crash to search further?
2. Or, even better, how to fix this?
Again, thx, I can assure you that using the forum is not intended to avoid work, but rather I am seriously stuck ...
Regards
Nico