Hi folks!
I am trying to set up OMV via Proxmox. I installed it as a LXC using the command from this site. I have 2 extra drives (one is added an LVM and the other as ZFS) besides the main one where OMV is installed. Because it is not set up as VM, I do not have access to hardware so I can add the drives. And for sure they are not accessible inside of OMV.
Any suggestions on what I can do? I would really like to run OMV as an LXC and not a VM as it takes up less resources.
Thank you so much!
Trying to access additional drives via Proxmox with LXC
-
-
I would really like to run OMV as an LXC and not a VM as it takes up less resources.
It has been discused over and over that OMV won't run properly on a LXC.
So, you better go with it on a VM.
-
Thank you, Soma. I though that if they made a script on https://tteck.github.io/Proxmox/, it was recommended.
Thank you for your advice. I will install in a VM in this case. -
You should run it in a VM. It's not possible to hardware passthrough on a CT. You could potentially mount the drives on the host and then share the mounts with the CT, but I don't see any reason to use OMV at that point. You might as well use proxmox as the NAS.
-
Thank you, Soma. I though that if they made a script on https://tteck.github.io/Proxmox/, it was recommended.
Thank you for your advice. I will install in a VM in this case.Someone ought to ask tteck to remove that omv LXC. There's a nasty hack that get's it partly working, but in fact it's useless.
-
ygreq
Hat den Titel des Themas von „Trying to access additional drives via Proxmox“ zu „Trying to access additional drives via Proxmox with LXC“ geändert.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!