Hello!
After rebooting omv shows the Picture I Attached on the screen. It keeps switching the number on the left side, and so far it has been doing it for 5 minutes.
What does this mean??
When reboot, the screen on console show this
-
- OMV 1.0
- audi30tdi
-
-
Will that come to an end or does it loop forever? I've seen similar messages on a system with a defective RAM stick.
-
The problem with this is that important part of the trace if what the screens eats before those errors. So is hard to tell what could it be. But indeed does look like HW problem. Can you actually boot to full system?
-
-
It did go and go for about 30-35min, then I unplug the power and start again everything started ok. I also tried a reboot and not a problem this time. The hardware is completely new, but it could be some bad hardware nevertheless.
Should I be worry, or think it just was a bad time??
-
dmesg is the first log after grub kernel load. Plenty of hw errors are displayed there if they occur.
-
How can I look into this log??
I remember when I install this system, and boot up I got something like firmware bug cpu1, could it be from that??
-
-
No idea. different hw platforms, different kernel is hard to debug. All those reports go directly to debian or the upstream kernel. Not to much we can do here.
You can always go copy and paste the error in google to check what's comes from mailing lists around for kernel bugs
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!