Hi 
I have a problem with my wlan interface (Realtek RTL8188EE).
I installed the device driver (Realtek: linux_mac80211_0012.0207.2013.tar.bz2) and configured (OMV 1.7) with:
interfaces:
Code
# The loopback network interface
auto lo
iface lo inet loopback
iface lo inet6 loopback
# eth0 network interface
auto eth0
allow-hotplug eth0
iface eth0 inet static
address 192.168.178.3
gateway 192.168.178.1
netmask 255.255.255.0
post-up /sbin/ifconfig $IFACE mtu 1500
dns-nameservers 192.168.178.1
iface eth0 inet6 manual
pre-down ip -6 addr flush dev eth0
# wlan0 network interface
auto wlan0
allow-hotplug wlan0
iface wlan0 inet dhcp
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
post-up route add default gw 192.168.178.1 wlan0
iface wlan0 inet6 manual
pre-down ip -6 addr flush dev wlan0The wlan work well, if I start the omv with ethernet cable connection.
I can shutdown the eth0 interface and the wlan doing his job.
ip link:
Code
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN mode DEFAULT
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc pfifo_fast state DOWN mode DEFAULT qlen 1000
link/ether d0:50:99:25:78:c0 brd ff:ff:ff:ff:ff:ff
3: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode DORMANT qlen 1000
link/ether 64:5a:04:4c:2f:c6 brd ff:ff:ff:ff:ff:ffBut if I start the omv without any cable connection, i have no wlan.
Have anyone a idea what I must configure that the wlan come up after reboot
without a cable connection?
Thanks for your help.