Hi,
I'm new to OMV, please be gentle if I ask noob questions.
I have installed OMV as guest under KVM (in Proxmox). I have two sata HDD's defined as virtio to the OMV guest, like:
qm set 101 -virtio0 /dev/disk/by-id/ata-ST1000DM003-xxxxxxxxxx
I try to get SMART data from the GUI of OMV (S.M.A.R.T. --> Devices --> Information), but that turns out to give an error:
Error #6000: exception 'OMVException' with message 'Failed to get S.M.A.R.T. information (device=/dev/vda): ... /dev/vda: Unable to detect device type Smartctl: please specify device type with the -d option.
When I logon via SSH, the following command runs OK, on command line: smartctl --all -d sat /dev/vda ----> it reurns the proper SMART data were I'm looking for
Found some suggestions to update config.xml, without further instructions. I tried the following:
<smart>
....
<device>
<uuid>8a19c120-2a62-4d7a-a568-abf36314eb36</uuid>
<devicefile>/dev/vda</devicefile>
<enable>1</enable>
<type>sat</type>
</device>
....
</smart>
So I inserted the type 'sat', before my update it read as <type></type>
After that a re-boot, but no luck. Still no SMART info through the OMV GUI.
Any suggestions?
Running OMV