Saw a new RPi4 - based NAS on kickstarter.
https://www.kickstarter.com/pr…powered-by-raspberry-pi-4
Nice:
12 volt
4 bay SATA
RPi4.
RPi4 ports and pins still available.
Pretty.
Not so nice:
Early Bird gone ( I snagged one).
Max 10TB per drive.
Mix of 2x2.5" and 2x3.5"
4xSATA via one USB3 port.
Could the fan be any louder? https://v.kickstarter.com/1631…ef58ce9e024_h264_high.mp4
They should of made it an inch taller to fit a lower RPM fan. I use fans with a larger pitch/yaw in my smaller ( < shoebox) PC's and even those have a hum (although not too bad). In a 3D printer (Elegoo Saturn), I think I'm use the exact same fan by spec and it's so loud I removed it and just run the steppers hot :-/
Could the fan be any louder? https://v.kickstarter.com/1631…ef58ce9e024_h264_high.mp4
that noise looks like a food mixer 
Argon makes very good cases. I wouldn't judge it by bad audio from a prototype in a video.
Argon makes very good cases. I wouldn't judge it by bad audio from a prototype in a video.
I don't doubt it, but you won't deny that the video is funny ... 
Yes, I really went wrong with my (now deleted) post.
I don't drink very often; but on this occasion, I had been boozing up and then I went online. What could go wrong?
Regardless of what I thought of Adoby's post (and it turns out I wasn't thinking at all), I should have known better than to challenge a Moderator.
I apologize for my lack of judgement. And I learned a lesson about mixing alcohol and the internet.
Don’t have an account yet? Register yourself now and be a part of our community!
