A very good evening to you all!
I've just started putting my NAS together using a Dell PowerEdge T310 with a PERC 6/i RAID card (after I brought it I found that the PERC 6/i is limited to 2tb drives, but that's ok, I'm working around it), but I've run into a little issue.
I can't get the web interface smart monitoring to register the (test) drive on the RAID controller.
Disk is configured as a Raid 0 array on it's own (going to use 4 single virtual disks, no actual RAID in either hardware or software), the web interface says the status of the drive is "unknown". Attempting to make a scheduled test and run it gives me an error of "unable to open device" and tells me to manually add device parameters for "megaraid".
SHH'ing into the box and running smartctl with the "-a -d megaraid,0 /dev/sda" parameter gives me full S.M.A.R.T. information for the connected drive.
But how do I get this to be implemented through the web interface?
I should probably also add I've gone ahead & added the "hwraid" repo in and installed all Megaraid related tools.
Thank you for any help you may be able to provide in advance.
Sui